DRY-TREAT 100N

Typical applications: DRY-TREAT 100N is suitable for a wide variety of applications, including marine infrastructure (such as bridges, wharves and jetties), building facades, car parks and swimming pool surrounds.

Benefits: DRY-TREAT 100N is able to repel water and water-borne chloride ion salts; non film-forming; able to work without changing the appearance of the surface – keeps the original look; able to greatly reduce water uptake and minimize moss growth, freeze thaw spalling and efflorescence; an excellent chloride ion salt screen by 98 per cent – ideal for marine and pool areas; highly water vapour permeable – able to breathe so there is no build-up of subsurface moisture allowing it dry out; deeply penetrating – protecting against weathering and wearing; solvent free – 100 per cent active ingredient; very alkali resistant – won’t breakdown in contact with cement based materials, and able to seal hairline cracks up to 0.3 mm (0.012 in.) and does not flake or peel. The treatment can extend the service life of concrete by up to 100 years.

Warranty: A 30-YEAR PERFORMANCE WARRANTY is offered when applied by an accredited applicator following our written instructions and tested by us.

Application rates: Total application rate is approximately one litre per 1.66 sq. metres depending on absorption.

How to use:
1. ALWAYS TEST PRODUCT ON A SMALL AREA FIRST and allow a 24 hour cure time to determine the ease of application and desired results.
2. Ensure surfaces to be treated are dry, clean and free of residues.
3. Product is to be applied without thinning.
4. Generously saturate the surface with product using a low-pressure hand spray, a clean brush, or similar. Surface should have a mirror-like “wet” look for 3-5 seconds. Avoid contact with surrounding areas.
5. After a minimum of 12 hours, repeat Step 4. Total application rate is approximately one litre per 1.66 sq. metres depending on absorption.
6. Allow 10 minutes for product to penetrate surface then polish surface with a clean white dry cloth to remove excess product.
7. Clean equipment with methylated spirits.
8. Sealer will not prevent surface etching or wear and may lighten or darken some surfaces.

Precautions: Do not take internally. Apply when surface temperature is between 5 – 35ºC (40 – 95ºF). Avoid moisture contact with the surface for six hours after application. Protect surrounding areas from over-spray. Keep away from drains, plants, water and soil. Use only in well-ventilated areas. Use a positive pressure respirator if ventilation is inadequate. Wear suitable solvent-resistant gloves, protective clothing, safety goggles and an organic vapour respirator during application. Avoid applying in windy conditions. Wash hands thoroughly.

Active content: Greater than 99 per cent isobutyl triethoxy silane.

Pack size: 20 and 200 litre steel drums.

Dry-Treat Dealer. Accredited Applicator.
189 Marua Rd Ellerslie
Auckland Auckland New Zealand
Contact : Dino Gagas Phone 09 526 4581 , Fax 09 526 5909 , Mobile 021-930 066
Aucland
Website : http://www.lustre.co.nz
Email :